Ok now that the motor runs i need to work out the plumbing properly Does anyone have any close pics of the inlet manifold with vac lines attached? I haven't been able to find any clear ones of complete motors also where does the water come from for the throttle body?
keep it simple block everything off. you only need 1 vacum line from the dizzy if it has vacum advance and one to the computer if its an aftermatket and these go on to the plenum chamber. water 1 in and 1 out to the radiator and 1 in 1 out for the heater if you hook it up.
I realize that but I need to have it looking stock for registration and hoses hanging off with bolts in them (as it is now) does not look factory. which one is the vac line for the brake booster??
Thanks Ben
rather then use hoses with bolts remove the plugs where the hoses join with blanking bungs. i used anodized allen key ones or cut them off and weld them up. the brake booster should connect on the bottom of the inlet manifold around cylinder 4.
I was told by my mate that its not for cooling but heating (can be seen in pic four). I have some pics of my motor. from what i can tell Its is a bit of a bitsa. It looks like a 117 motor , Itec Manifold (Also have 117 forward facing) and an ECGI computer.
